2007年5月20日

TRG esc2

















PICTURE 1

















PICTURE 2

標籤:

3 Comments:

At 4:25 下午, Blogger Yu said...

Walkthrough for TRG Esc 2:


In the beginning:
Take the 4 magnets off paper.
"Item View" the 4 magnets, click to reveal backside (note the 4 numbers and 4 colors).
Pick up paper 1 from floor.
"Item view" paper 1, click on bottom edge to turn it over to see the birds.
Turn right to wall with crack, click on lower part of crack, get paper 2.
While zoomed into the crack, click on highest point of crack to view up, get paper 3.
Turn right to shaft, click around the shaft door a few times to drop it down.

Opening Safe:
Turn on safe panel. Select paper 3, superimpose it onto panel. (NOT "Item View")
Note order of buttons to push, also note bird button.
Push buttons in order found, with colors found on back of magnets.
(If successful, all lights would turn from white to blue)
Click on bar on right to open safe. Take screwdriver.

In Shaft:
Leaving the safe open, turn to shaft, use screwdriver on screws.
Climb down ladder, while viewing ladder from bottom, click on the right side of the middle step (it should look a little different)
Use screwdriver on screws, take ladder step.
"Item View" ladder step, click on lower end to see flashlight.
"Item View" flashlight, click on far end to turn it on, click on blue tape to peel it off.
Turn to face shaft door, peek into keyhole to see an orange room (room from Esc 1, perhaps?)
Click above shaft door on the left side to show scratch marks, click on right side of scratch marks and pick up two orange brackets.
Go back up to blue room.

Get shaft door key:
With flashlight on, look into round hole inside the safe, see key.
"Item View" flashlight, click on the 4 magnets to attach them to front of the light.
Select the magnet-light to get key out of hole.
Keep the safe door open.

 
At 4:26 下午, Blogger Yu said...

ENDING 1
Spoiler:
Using shaft key (from hole behind the safe) when the shaft is down .... brings you into the orange room (was that from Esc 1?) He says "I escaped!!...... Did I ....... ?"

ENDING 2
Spoiler:
Escaping from the ceiling (shaft is up). He says "tired......"

ENDING 3 (I suppose this is the true ending?)
Spoiler:
You take the ceiling panel, power on the bird safe, input the bird code, and exit through the crack on the wall (it's a door). He says "Wa!! It's a door!! It opened!!!"

 
At 4:31 下午, Blogger Yu said...

FOR ENDING 1:

take shaft key, go down ladder, and open shaft door down there.



Moving on?


Ceiling:
View shaft from above, note the 8 screw holes.
Add the orange brackets to the middle holes.
Use pole (ladder step) on brackets to pull the frame out.
Push round button to raise the shaft up.
Use shaft door key to open shaft door.
Climb up, get ceiling key.
Use ceiling key on ceiling door.

FOR ENDING 2:

get out this way.



Moving on?


Click on red dot in this attachment(PICTURE 1)
instead of getting out.
Click there to get ceiling panel.
"Item view" ceiling panel, turn to back and get a magnetic chip.

Bird code:
Close the safe door, but don't turn it off yet! Keep the lights blue.
The lights on the safe should still be blue, right? If not, click the 1 2 3 4 buttons to make the lights blue again.
Click on bird button to red. Now the lights should turn bird-shaped.
Click on bar on right to open "Kick a 'K' Machine" panel.
Put in magnetic chip to power number pad.


Look at the figure on this ID-card-looking device, it will show colors and numbers.
0: blank
1: white
2: red
3: orange
4: yellow
5: green
6: blue
7: black

Then in this case
(PICTURE 2)
black.......7
-----.......0
white.......1
-----.......0
orange.....3
white.......1
yellow......4

7010314 is bird code.

FOR ENDING 3:

type in bird code, hit Enter.

 

發佈留言

<< Home